BMW 501

We install the 123 electronics in the original housing of your distributor. The housing will be provided with an opening on the side through which the ignition curve can be set. Of course, the opening can be closed with a screw / rubber cap that we will provide. There is no new distributor cap and no new distributor rotor supplied, but we deliver the converted distributor with the cap and the rotor that we received from you, which will still fit your distributor after the conversion. You are welcome to purchase a new distributor cap and a new rotor in our shop.

The sales conditions and the price are predicated upon the fact that you send us a specifically correct, complete and clean distributor (including distributor cap and rotor) for the conversion. If any of the components of your distributor (except breaker contacts, contact plate and ignition adjustment mechanism, as these are replaced as such) show serious damage, we will invoice their repair or replacement separately, which we would notify you of before the repair.

This ignition distributor does not come with vehicle-specific ignition curves. Rather, it contains a selection of 16 ignition curves, which can be found in the installation manual on the right side of this page under 'Technical Info'.

Our ignition distributors require ignition coils with at least 1 ohm resistance in the primary circuit.
We recommend not to use ignition cables with a copper core. The electronics in the ignition distributor may be interfered with the electromagnetic fields induced by these cables.

You can find suitable ignition coils and ignition cables below on this page.